OMG Toggle Fastener 1,000ct | TW001-X

(0)No Reviews yet
$367.95
SKU: TW001-X
PACKAGING QTY: 1,000 count

Details

OMG X-Wing Toggle Fastener for use with XHD screw


The OMG X-Wing is a toggle fastener for attaching insulation to a variety of decks including gypsum, cementitious wood fiber, and lightweight insulating concrete decks.

The X-Wing is designed specifically for use with an OMG Extra Heavy Duty (XHD) fastener and a standard 3-inch (75mm) insulation plate, both sold separately.

The OMG X-Wing is not designed for attaching roof membrane under any conditions

OMG X-Wings are provided unassembled in quantities of 1,000 pieces.

Physical Data

  • Material: Zinc plated
  • Weight 31 pounds


Features & Benefits

  • Fast and easy assembly


Application

  • A 3/4-in. (20mm) pilot hole must be drilled entirely through the deck. Using a screw gun,* drive the fastener until the wing is drawn up against the underside of the deck and the attachment is tight.
  • The fastener must be long enough to allow a minimum of 1-1/2-in. (38mm) clearance on the underside of the deck in order for the wing to open. Not recommended for securing with fasteners less than 4-in. (100mm) long.
  • NOTE: Prior to job-start, contact OMG to perform a pullout test to determine pullout values.Also, care must be taken not to overdrive the fastener causing subsequent damage to the insulation facer. Fastener must be tight enough so that the plate does not turn.
  • *For best results use a variable speed 02500 RPM screw gun. The fastener should always be tested on site by an OMG representative to determine performance.


Fasteners & Plates

  • Use an OMG #15 Extra Heavy Duty (XHD) fastener and a 3-in. (75mm) steel insulation plate. Fasteners and plates sold separately. OMG XHD Fasteners available in lengths to 16-inches (405mm) . Contact OMG to determine the appropriate plate for your application.
  • Predrill all deck types using a 3/4-in. (20mm) drill bit.

Ratings & Reviews

No reviews available

Be the first to Write a Review